Bootstrap - From cassette to disk
This project was based on my need for a
Today I know that
This table shows the required setting.
|DOS||Total Tracks||Directory Track||DAM|
I began to think about whether it would be possible to create on a
The complete process to create the disk takes about 35 minutes. This <ZIP archive>
contains WAV files to permit you to create a
The first step is to protect the RAM which will hold the track data. To do so, set the MEMORY SIZE to 35000.
The next step is to set up the TRS-80 so that it can load data from a WAV file. There are a number of ways to this.
- You could plug a cassette recorder (make sure it is mono and not stereo) LINE IN into your PC's LINE OUT and use any WAV playing program to send the two WAV files through the LINE OUT to the tape player. Volume is key and it may take many tries to get everything correct.
- use a utility called PLAYCAS
PLAYCAS(http://knut.one/PlayCAS.htm) allows you to use your PC as a cassette player for your TRS-80 by connecting your TRS-80 cassette input ('Ear' Output) into the PC's headphones output. This <ZIP archive> contains several CAS files. One is the bootstrap program and the others are some DOS versions.
- use a Linux system like a Raspberry Pi
You need one cable and three commands.
amixer sset Headphone 100% aplay bootstrap.wav aplay tracks.wav
Once you have set the MEMORY SIZE and set up your Model I so that it can load the WAV file,
the next step is to type in SYSTEM from the READY prompt.
At the first '*?' prompt, type 'B' and hit enter. There should be 2 stars in the upper right hand corner
of the screen, with one of the two flashing periodically. If one of the stars changes to 'C',
there was an error and you will need to try again.
If you do not get a 'C' and then another '*?' prompt shows up, you need to prepare the system for the next WAV file. If you put them back to back on the same cassette, then it is all ready. If you are using PlayCAS or an emulator such as XTRS, you need to load the second CAS file so it is ready to go.
Once the data WAV file is ready, respond to the second '*?' prompt by typing type / and hitting enter. You should see 'Bootstrap v3.9 (Model I)' appear on the screen.
Now is the time to be very patient ... for about 35 minutes ...
If all goes well, you will have a Model I NEWDOS/80 boot disk.
This is what the screen will show when everything went well. Now just reboot the system, this time from the new floppy disk.